switch port

According to the analyzed results and control rules, the dynamic link libraries technic is applied, washing process is controlled with the switch quantity output of computer parallel port.

根据分析结果结合控制规则，采用动态连接库技术实现计算机并口输出开关量控制洗涤过程。

In this case, a single Cisco 1700 Series modular access router configured with a Cisco ADSL WIC and a Cisco 4-port Fast Ethernet Switch WIC can be deployed to meet these requirements.

在这种情况下，一个单一的思科1700系列模块化接入路由器配置了思科公司的ADSL WIC和思科4端口快速以太网交换机WIC可以部署以满足这些要求。

MAC Address binding with the Switch Port is one function of switch port security management.

MAC地址与交换机端口绑定是交换机端口安全管理功能之一.

A variable port speed shared memory switch

一种端口速率可变的共享存储器交换

The network engineer uses a portable integrated analyzer to drill into the switch and view the activity on each switch port.

网络工程师使用便携式集成分析仪深入交换机观察每一个交换机端口上的活动情况。

Each port on a switch that uses the Spanning-Tree Protocol has one of five states, Figure.

使用扩充树协定的交换器,每个埠有五种状态, 如图所示.

And a Visual Basic parallel port control program was used to drive electromagnetical valves through an amplifying circuit. Thus, the switch of gas channels in pneumatic micropump can be controlled.

同时，采用VISUAL BASIC程序语言编制并行接口控制程序，经自行设计的放大电路作用后驱动两位三通电磁阀，实现对气动微泵各气路间的切换的控制。

If the switch does not recognize the MAC Address, it will not know which port to copy the frame to.

如果交换机不承认mac地址，它也不会知道哪个港口复制帧。

In the first quarter from 2001 to 2002, Chinese switch market has been keeping higher growth rate all the time and increment is up to about 3 million ( the port is counted) each season.

从2001年到2002年第一季度，中国交换机市场一直保持较高的增长速度，每季增量都达300万（端口数）左右；

If the virtual appliance is deployed to a different Power server in the server system pool, VLAN 2012 is added to the switch port automatically for communication between virtual servers in different physical servers ( see Figure 14).

如果虚拟设备部署到服务器系统池中某个不同的Power服务器中，VLAN2012会自动添加到交换机端口中，以实现不同物理服务器中的虚拟服务器之间的通信（参见图14）。

EIO which integrates with the function of I/ O control and RS232/ RS485serial port communication is a Ethernet device. The EIO devices have the function of switch output, switch input and serial port communication.

EIO是同时集成I/O控制和RS232/RS485串口通信功能的以太网设备，同时具备开关量输出、开关量采集、串口通信等功能。

Every port should be equipped with switch and appropriate fuse wire, the switch of each port should be cut off before starting the machine.

每一用电端均应装有开关及适当容量的熔断丝，开车前各用电端的开关均应置于断开状态。